Page 1 of 1

Catalytic convertor, brake discs, sprockets

Posted: Thu Feb 22, 2018 12:41 pm
by Waynus
So, installed an inline convertor today.
Really love the Titanium headers, but find them to be a bit too loud for nature ride-outs.
Also, hope the German coppers will let me pass if I can show them the fitment of this convertor (Too bad, not E3 approved for use with the Nuda)
Found an Akrapovic inline cat on Ebay (€80) and manage to fit it with only minor modifications.
Will report back after the first ride-out and dyno run.
Image
Image
Image

Re: Catalytic convertor

Posted: Mon Mar 26, 2018 10:25 am
by Waynus
Didn't had the opportuntiy to get it dyno'ed, but did took her on a ride last weekend.
Sound level has been reduced but not by as much as I was hoping.
Tone has been lowered, so less disturbing unless you go above 5,000rpm.
All the rawness is still there. So I'm really liking it so far !

Re: Catalytic convertor, brake discs, sprockets

Posted: Sat Jun 16, 2018 12:05 pm
by Waynus
Finaly, a set of floating front discs ! Been wanting these for ages...
Keen to try them out, but still have to decide on what size of (dampened) front and (alloy) rear sprockets to fit...

Re: Catalytic convertor, brake discs, sprockets

Posted: Sun Jun 17, 2018 3:19 pm
by Husabergjay
No pics of the bike with the headers on mate?

Would love a set of these for mine